SMTP 354 Start Mail Input vs 503 Bad Sequence
SMTP 354 (Start Mail Input) is a 3xx Positive Intermediate response, while 503 (Bad Sequence) is a 5xx Permanent Negative response. 354 indicates that the server is ready to receive the message body. The client should begin sending the email content (headers and body) and terminate with a single line containing only a period (CRLF.CRLF). In contrast, 503 means that the commands were sent in the wrong order. SMTP requires a specific command sequence (EHLO, MAIL FROM, RCPT TO, DATA) and this error indicates a step was skipped or repeated.
विवरण
The server is ready to receive the message body. The client should begin sending the email content (headers and body) and terminate with a single line containing only a period (CRLF.CRLF).
जब आप इसे देखें
After sending the DATA command. The server is now waiting for you to type or stream the email message, ending with a dot on its own line.
कैसे ठीक करें
Send your message content followed by a line with just a period (.) to signal the end. If you get an error after this, check that your message does not contain a bare period on a line by itself within the body.
विवरण
The commands were sent in the wrong order. SMTP requires a specific command sequence (EHLO, MAIL FROM, RCPT TO, DATA) and this error indicates a step was skipped or repeated.
जब आप इसे देखें
When sending DATA before RCPT TO, or MAIL FROM before EHLO. The server enforces the correct SMTP command sequence and you have sent a command out of order.
कैसे ठीक करें
Follow the proper SMTP command sequence: EHLO/HELO first, then MAIL FROM, then RCPT TO (one or more), then DATA. Reset with RSET if you need to start over.
मुख्य अंतर
354 is a 3xx Positive Intermediate response, while 503 is a 5xx Permanent Negative response.
SMTP 354: The server is ready to receive the message body. The client should begin sending the email content (headers and body) and terminate with a single line containing only a period (CRLF.CRLF).
SMTP 503: The commands were sent in the wrong order. SMTP requires a specific command sequence (EHLO, MAIL FROM, RCPT TO, DATA) and this error indicates a step was skipped or repeated.
You encounter 354 when after sending the DATA command. The server is now waiting for you to type or stream the email message, ending with a dot on its own line.
You encounter 503 when when sending DATA before RCPT TO, or MAIL FROM before EHLO. The server enforces the correct SMTP command sequence and you have sent a command out of order.
कब किसका उपयोग करें
For 354 (Start Mail Input): Send your message content followed by a line with just a period (.) to signal the end. If you get an error after this, check that your message does not contain a bare period on a line by itself within the body. For 503 (Bad Sequence): Follow the proper SMTP command sequence: EHLO/HELO first, then MAIL FROM, then RCPT TO (one or more), then DATA. Reset with RSET if you need to start over.